McAfee M-2750 - Network Security Platform Podręcznik Użytkownika Pobierz pdf (Strona 4)

The required settings for HyperTerminal

are:

• Baud rate: 38400 • Stop Bits: 1

• Number of Bits: 8 • Control Flow: None

• Parity: None

Plug the female end of a power cable into the power inlet and plug the other end into a power

source. The Sensor ships with standard US power and international cables.

The M-2750 does not have a power switch; you need to only plug the power cable into

a power source.

3 Cable the Monitoring ports

This procedure describes how to cable a Sensor to run in in-line mode.

Plug the cable appropriate for use with

your SFP module into one of the

Monitoring ports labeled xA (for

example, 1A).

McAfee supports only those SFP

modules purchased through

McAfee or from a

McAfee-approved vendor.

Plug another cable into the peer of the

port used in the earlier step. This port will be labeled xB (for example, 1B).

Connect the other end of each cable to the network devices that you want to monitor. (For

example, if you plan to monitor traffic between a switch and a router, connect the cable

connected to 1A to the router and the one connected to 1B to the switch.)

For instructions on how to cable the Sensor to run in other operating modes, see the

McAfee Network Security Platform Sensor Product Guide for your Sensor model.

4 Install the Manager Software

For detailed instructions, refer to McAfee Network Security Platform Installation Guide.

You must have administrator privileges on the target Windows server to install the Manager

software.

A MySQL database is included with the Manager and is installed (embedded) automatically

on your target Windows server during this process.

1 2 3 4 5 6 7 8 9 10 11 12

Brak uwag

McAfee M-2750 - Network Security Platform Podręcznik Użytkownika Strona 4